Again, some free, some not, and some unbelievable expensive. There is a ton of software out there to use. If you have not used any modeling software in the past then you will have to spend some time getting familiar with how the software works. Also you will need a lot of pictures of the plane from various angles to be able to model the finer details.Ĭhoose the 3d modeling program you would like to use or you are familiar with. One front, one side, and one top profile that are from the same source, here is a website that I use for this. On the other hand if you would like to start from the ground up, you will need to find 3 good profiles of the plane. ![]() Some you may have to attribute the original maker of the model, and some may be a royalty free license allowing you to edit and resell if it is not the same format as the original. Some have special licenses that allow or deny you to edit and use the models. Please keep in mind that not all models may be used. If you decide that you would rather start with a base 3d model and edit it, there are a lot of websites that you can download models from. ![]() Once you have chosen the model you want to use then it’s a matter of deciding to use an existing 3D model and editing it or start from the bottom up. Also make sure that it is not the most complicated design as that will discourage someone that is new to this. There are plenty of resources on the web to aid in this. I have included a list of the materials I used and links for them.ġ) Receiver, I use a Futaba radio, but use whatever radio and receiver you have as long as it has atleast 4 channelsĪnd few various screws for the landing gear mounts.Ĭhoose a model that you like. The reading is brief, but there are a lot of pictures. This is an intro on how to start 3d modeling and printing your own RC aircraft. This instructable is written as if the reader has experience in building RC airplanes, so I will not be going over how to set up the radio or setting throws. Lesson learned, recalculate CoG (center of gravity) before you just give it a try. There are videos at the end, but I cut it off as soon as it left the ground as the ground came back just as fast as it took off. ![]() Spoiler alert, after many months of designing in a 3d cad program and printing it, I did get the chance to maiden it, but the first attempt was unsuccessful and the second attempt the actual flight was very (very) short. I choose a simple delta wing (Mirage 2000), with the thought that it would be would be the best bet for the first attempt. I went from SR71 blackbirds all the way thru F-14 tomcats, but in the end I started with a simpler design. There were so many that I liked that it made the decision tough. I started off by figuring out what airplane I would like to do. I will tell you I have never stick built an rc plane so I did not have the background to figure out things like wing profiles. At first I purchased some of 3Dlabprint ( rc airplanes to test them out. I would like to share my attempt at 3d designing and printing my own rc airplane.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |